National Service Hotline:
+8618664582139
Location:Home page > Case Update > Case broadcast >
Testing method for air tightness of copper sheet stamping parts

Through the punch and die on the plate, strip, pipe and profile and other external force, make it produce plastic deformation or separation, so as to obtain the desired shape and size of the workpiece forming processing method, the workpiece is the stamping part

Stamping can produce work pieces with stiffeners, ribs, undulation or flanging, which are difficult to be manufactured by other methods, so as to improve their rigidity. Due to the use of precision mold, the accuracy of work pieces can reach micron level, and the repeatability is high, and the specifications are consistent, so that holes and bumps can be punched. Compared with castings and forgings, stamping parts are thin, uniform, light and strong

This time we are going to test the stamping parts. There are many copper bubbles on the stamping parts. If we are careless in stamping, it is very likely that small bubbles with cracks will be punched out. The stamping parts with cracks do not meet the requirements of qualified products of customers. At the same time, because the product defects are not easy to be found by the naked eye, so it is necessary to do some research on these stamping copper sheetsAir tightness test

It can be seen from the shape of the stamping part that the copper sheet stamping part has no air filling port, and the product is relatively thin and small, so it is necessary to make a very consistent mold for the product, and use the indirect test method to test the tightness of the product. At the same time, the output of customers is relatively large, I hope we can do a one out two air tightness testing equipment, so that we can test two products at the same time.

The requirement of this air tightness test is to detect the products whose bubbles are crushed on the stamping parts. If the products are crushed, the pressure in the die will enter into the stamping parts when they are inflated. According to the change of air pressure in the die, the defective products can be detected.

According to the repeated tests of the product, the final air tightness test parameters set for this stamping part are: test pressure 10KPA, upper leakage limit 0.05kpa, inflation time 5S, pressure stabilization time 5S, test time 5S

After setting the test parameters, the air tightness tester and the test tooling can be connected together through the factory air source. At the initial stage of each test, test a qualified product first, and check whether the test result is OK; Test a bad product again to see if the test result is bad. After the test results are consistent with the actual situation of the product, the product can be batch tested.

Hermes technology has tested the air tightness of tens of thousands of productsAir tightness testThere are abundant and mature cases. Test products range from small household appliances, electronic products, to medical products and industrial products, can provide you with test case sharing.

If you are interested in air tightness testing equipment, please call Harris technology.

Related news
Copyright © 2021 All Rights Reserved Hirays Technology Co.,Ltd. record number:粤ICP备08110193号 本站基于:米拓企业建站系统搭建